Resurfacing puts a thin, bonded layer over concrete that's still sound underneath. Fort Myers Concrete Experts will look at your slab and tell you plainly whether it qualifies or whether you're better off with a different fix. That answer is free and comes before you decide anything.
Is my slab a good candidate for resurfacing?
Yes, if the top is flaking, pitted or stained but the slab itself is still flat and in one piece. Resurfacing fixes the surface. It doesn't fix what's under it.
It's the wrong job if the slab has sunk, if sections have broken into pieces that move when you step on them, or if the cracks run deep through the slab. Those need a tear-out or structural repair, and a thin coat over them would fail. A slab with just a few small blemishes may not need anything done, and that's the answer you'll get from us.
Worth comparing with polished concrete floors. Searching for a concrete contractor in Fort Myers? Our home page covers it.
Helpful next: What Concrete Work Costs and What Moves the Price · Warning Signs You Need Concrete Work
How we prep and apply the resurfacing material
The new layer only holds if it bonds to clean, damp concrete, so prep comes first. The hose goes over the slab, then the industrial squeegee on its long handle drags the puddles off. The surface should be damp with no puddles left.
Each batch of compound is mixed in a 5-gallon bucket, and we break the slab into sections of 144 square feet or less. Control and expansion joints stay clear of compound. Those joints are where the slab moves, and if we fill them the new finish will crack along the same lines.

What does resurfacing cost, and what moves the number?
Concrete driveway resurfacing runs $2.50 to $8 per square foot.
The total follows square footage first, then the condition of the surface and how many joints we have to keep clear as we work. A big, open slab in decent shape lands at the cheaper end of that range. A smaller or more broken-up layout with more joints to work around sits higher. The written quote lays out the prep, the joint protection and the per-square-foot price before any work starts.
Do I need a permit for driveway work in Fort Myers?
It depends on where the work sits. We work to the 8th Edition (2023) Florida Building Code for site work.
If your driveway reaches that far, we sort out the permit and the apron before we schedule the work.
What happens when you call Fort Myers Concrete Experts?
We ask what the surface is doing, how big the area is, and how old the concrete is, then book a visit to measure it and check the condition. There's no charge for the call, and nothing about finish or scheduling gets decided during it.
After the visit you get a written estimate. When a slab isn't a fit for resurfacing, you'll hear that from us rather than get an estimate for it. Call us to set up the visit.
You Might Also Need
What Goes Into the Work
For work like this, a few parts of the job:
- Keep new surfaces dry from rain for 6 hours minimum and above freezing for 24 hours; mist-cure for 24–48 hours if temperatures pass 90°F.
- Pre-wash oily or greasy concrete with concrete wash, then pressure-wash the surface thoroughly at 3,500 psi.
Straight Answers
Calling is the simplest way to start, no hard sell.
Estimates · No-pressure scheduling