Before anyone quotes you a new slab, you need to know whether the concrete or the base failed, because a patch over a moving base cracks again.
Is it the slab or the ground that failed?
Most slab failures here start below the concrete. The soil around Fort Myers is sand that drains poorly. Canaveral fine sand is somewhat poorly drained, and Myakka and Immokalee sands hold a seasonally high water table. After a hard storm or a wet summer, the base under your slab can sit saturated and soft, and that's when edges sink and cracks open. A new slab starts with the old concrete out and the subgrade checked and rebuilt. Wet sand also changes the dig itself, since a shallow water table can affect excavation and base preparation.
These questions come up on concrete driveway installation jobs. Shopping for a concrete contractor in Fort Myers? Our home page has more.
When does a slab need replacing instead of repairing?
Replace it when it's heavily cracked, sunken below the surrounding grade, or breaking up in chunks. Patching a slab that's still moving wastes money, because the repair cracks along with the rest. You don't need a new slab if the concrete is flat and in one piece and only the surface is worn, flaking or stained. That's a resurfacing or grinding job and costs far less. If your slab turns out to be sound, the cheaper surface fix is what we'll recommend.

What does a new slab or driveway cost?
A new slab falls between $3.50 and $16 per square foot; a driveway falls between $7 and $18. Three things move the number: breaking out and hauling off an old slab, digging out and rebuilding soft or wet ground, and whether a truck can reach the pour area. Ask for a typical range on the first call and you'll get one. Once we've seen the job, the firm figure goes on a written quote, and no work begins until you have it.
How is the new slab poured and finished?
Once the base is ready and the forms are set, the concrete goes in and we screed it with a straightedge to cut off the excess and bring it to grade. The bull float comes next, leveling out the humps and dips and embedding the coarse aggregate. We wait until the moisture sheen disappears before floating again. Finishing is either a steel trowel, which gives a smooth surface, or a broom drag, which leaves texture. Outdoors in Florida, where slabs get wet, brooming is usually the better choice. If the pour area is behind the house and a truck can't get close, we bring in a concrete pump. A pump adds cost, so on a backyard patio we check truck access before anything else.
Do you need a permit to pour a driveway in Lee County?
If any of the driveway work touches the public right-of-way in unincorporated Lee County, you need the county permit before anyone starts. That apron is part of the driveway scope and the price. The county permit applies to unincorporated addresses, so we confirm which side of the line yours is on before pricing.
What happens when you call us about a new slab?
The questions are simple: is there an old cracked slab or bare ground, about how large is the area, and which part of the lot is it on? Give us a rough size and we'll talk through where the job usually lands right then. Then we schedule a site visit, look at the grade and the existing concrete, and measure the area. You get a written quote with the scope broken out, and you don't have to decide anything on that first call.
Pricing Ranges
Most jobs land inside these ranges, and we'll go over what pushes a job toward either end.
$1.80–$14.50 per square foot
$7–$11 per square foot
$8–$20 per square foot
You Might Also Need
Straight Answers
Talk to a local pro at (239) 327-0168.
Estimates · No-pressure scheduling
Updated November 2026