Our first visit is a site walk with grade measurements, and the itemized quote that follows covers base work and materials before a single form goes in. You'll also learn whether you need a pour at all.
What does a concrete contractor do that a handyman won't?
We handle the work that has to be right before the concrete ever arrives: forming, setting grade, placing reinforcement, and finishing before the mix sets. A handyman can patch a small cosmetic chip. A full slab needs forms, steel, a crew big enough to place and finish the pour before it hardens, and a base that's been checked.
We do structural slabs and driveways, and we build them to the 8th Edition (2023) Florida Building Code. A small surface patch gets quoted as a patch, not a pour.
Next read: concrete repair and restoration. Hiring for a concrete contractor in Fort Myers? Start with our home page.
What happens on pour day?
Pour day starts with forms and stakes driven in to set the height and slope, so the slab drains where you want it to. Reinforcing steel goes onto the prepared base next, aligned to the spec, so it sits where it can carry load.
The base matters most here. Myakka fine sand turns up in Lee County project areas, and it can hold a seasonally high water table and drain poorly. We check the subgrade before the truck is called, because a wet, soft base is what makes a slab settle later.
When the truck arrives, the concrete goes down near where it will end up and is worked in around the edge forms and the steel until the air pockets are gone. Then we screed it with a straightedge to cut off the excess and bring it to grade. July highs here average about 91.6°F, so the finishers are in place before the first load, not after.

What drives the price of a pour?
The price comes from square footage, the reinforcement the slab needs, the finish you choose, and how hard the site is to work. Polished concrete floors run $1.80 to $14.50 per square foot, and the finish level and the condition of the existing slab move the number within that range. Exposed aggregate, where the top paste is washed away to show the stone underneath, runs $7 to $11 per square foot.
Site access and drainage add cost when they make the work slower. So does the right-of-way. In unincorporated Lee County, driveway work in the public right-of-way can't start until the county permit is issued, and the county requires a poured concrete or asphalt apron from the road edge to the right-of-way line. If your driveway meets the road, the apron is priced in.
Ask for a ballpark when you call and you'll get the typical range for that kind of job. The firm price is set after a site visit, and you get it on paper before any work begins.
Can your existing slab be repaired instead of replaced?
Often, yes. If the slab is still level and the ground under it hasn't washed out, scaling, shallow spalls, and light wear can be repaired or resurfaced without a tear-out. The median home here was built in 2001, so plenty of slabs are old, but age alone isn't a reason to replace one.
Repair is the wrong call when the slab has broken into tilted sections or water keeps carrying sand out from underneath. A patch over a slab that's still moving fails, usually by the next wet season. In that case we remove the damaged sections, fix the subgrade, and pour new reinforced concrete.
What happens when you call us?
The first questions are simple: which part of the property, what the slab is doing, and about how large it is. Soil types, steel sizes and slope angles are our problem, and nobody asks you to commit to anything on that call.
Next comes a site visit with a tape measure, a grade check, and a look at how the ground drains. We also check permit requirements before we write anything up. Then you get an itemized written quote covering excavation, base preparation, forms, reinforcement, and the finish. There's no pressure to sign on the spot.
Typical Fort Myers Pricing
Read these as planning figures, and we can talk through a typical range before anything is booked.
$7–$18 per square foot
$3.50–$16 per square foot
$8–$20 per square foot
You Might Also Need
Straight Answers
Reach us at (239) 327-0168, and there's nothing to sign.
Estimates · No-pressure scheduling
Updated November 2026